1Setting Telephone No - Minolta Di450 Service Manual

1.11.13.1 Setting Telephone No.
1. Be sure to input the number correctly by checking the Display. If an incorrect
number is input, press the Clear key and input the correct number again.
2. If the customer's office has its own switchboard, and the DT-105 is connected
to this system, be sure to include the access number for the outside telephone
line ("0" for example).
Also, the time it takes the office system to access the outside line varies depen-
ding on the type of system employed. Therefore, a wait (w) or pause (–) code
should be input between the access number and the regular phone number as
shown below.
If the time is more than 3 seconds, a wait (w) code should be input by pressing
the Energy Saver key.
If the time is 3 seconds or less, a pause (–) code should be input by pressing
the Interrupt key.
3. Further, if the signal method differs between the office system and the outside
line, it is necessary to input a pulse (P) or tone (T) code before the correspon-
ding set of numbers. Each time the Stop Key is pressed, a P (pulse) or T (tone)
code alternates on the Display.
Key
Interrupt key
Energy Saver key
P
T
Extension key (sharp)
#
Extension key (asterisk)
*
4. After the telephone number has been input, call the Center to inform them of
the details of the telephone number.
Rev. 1.1/10.00
1. Touch "TEL. NO." again to show it in reverse
video.
2. Press the Clear key.
3. Enter the telephone number (up to 19 digits)
of the Center from the 10-Key Pad.
Notes
Function Display
Pause -
Wait W
Pulse P
Tone T
#
*
I-97 Di450 / Di550