Minolta Di450 Service Manual page 148

1.1.13 Registration Adjustment
1.1.13.1 2 way Paper Feed Cabinet
1.1.13.2 Large Capacity Cabinet
Rev. 1.1/10.00
1. Pull out the Drawer and unload the paper
from the Drawer.
2. Loosen seven screws as shown.
3. Referring to the gauge on the bottom plate of
the Drawer, move the Guide Plates as
follows.
If the margin A is greater than the
specifications, move the Guide Plates toward
the rear as needed.
If the margin A is smaller than the
specifications, move the Guide Plates toward
the front as needed.
4. Make a test print again and check for correct
registration.
1. Press the Paper Descent Button of the 3rd
Drawer. This releases the 3rd Drawer
allowing you to slide it out of the machine.
I-19 Di450 / Di550