1.2.5
Checking for Skew Feed
1.2.6
Adjusting Skew Feed
Rev. 1.1/10.00
1. Plug in the power cord of the machine and
turn ON the Power Switch.
2. Check that the paper of the same size as the
Chart shipped with the unit is loaded in the
machine.
3. Place the Chart on the Document Handling
Tray and make 1-sided copies five
consecutive times.
Place the Chart crosswise on the Document
Handling Tray.
4. Fold each copy as shown and check for
deviation.
5. If the deviation is great, perform the following
adjustment procedures.
Specifications : 0±1mm
1. Raise the Document Handling Tray until it is
locked into position. Then, after loosening
the screw indicated by the arrow, remove the
two remaining screws and the Rear Cover.
I-29
Note
Di450 / Di550