Installing; Installing The Backup Battery - Minolta Di450 Service Manual

1.11.2

Installing

Before a DT-105 can be installed to the machine, it is necessary that user master
data be programmed at the Center.
If the user master data has not been programmed, it is not possible to execute test
transmission at the time of installation and subsequent data transmission. Make
sure that the data has been programmed. (Check for Password, which is a person-
al computer ID number set for each DT-105, DT-ID, which is a DT-105 ID number,
and TEL, which is the telephone number of the Center.)
Check also the type of the office system implemented at the user's premises
(whether pulse dialing or tone), depending on which different settings of the DT-105
apply.
Before setting up, be sure to unplug the power cord of the machine.
DO NOT make copies until the initial transmission has been completed. Making
copies may cause the count data to differ between the Center and the DT-105.
When the initial data setting mode is set again, once the initial data has been input,
the input data will be cancelled and you must input the initial data again.
1.11.3

Installing the Backup Battery

Di450 / Di550
Note
1. Remove the Cover.
2. Plug the connector of the Backup Battery into
CN2.
Leave the Cover opened.
I-84
Note
Rev. 1.1/10.00