Minolta Di450 Service Manual page 177

For FN-106
: Tape
Cushion
Note
Do not remove this part!
Cushion
Note
Make sure that the Finisher is installed on a level surface.
Once the Finisher has been installed, do not move it unless absolutely necessary.
If it becomes absolutely necessary to move the Finisher, remove the Pipe both from
it and the machine.
After the Finisher has been relocated, attach the Pipe back again by following the
steps given in "Attaching the Pipe."
When moving the Finisher, press the side opposite to the Tray to prevent the
Finisher from toppling over.
Di450 / Di550 I-48 Rev. 1.1/10.00