Minolta Di450 Service Manual page 377

6. Press the Clear key to clear the current
setting value.
7. Use the 10-key pad to change the setting
value.
Setting Instructions
If width A is longer than the specifications, make the setting value smaller than the current
one.
If width A is shorter than the specifications, make the setting value greater than the current
one.
8. Press the Start key to let the copier produce a test pattern.
9. Check to see if width A on the test pattern is up to the specifications.
If it is outside the specified range, change the setting value and make a check again.
10. If width A falls within the specified range, touch [END] to validate the setting value.
Use to clear the
setting value.
Use to enter the
setting value.
Setting Value
D-96
3
4 5 6
7 8 9
0 C
4002D519AA
4002D513CB