Minolta Di450 Service Manual page 285

No. Part Name
1 Original Glass
2 EDH Glass
3 EDH Glass Holder Raise No.13.
4 Control Panel
5 Front Door
6 1st Drawer
7 2nd Drawer
8 Middle Left Door
9 Upper Left Door
(Exit/Duplex
Switching Unit)
10 Filter Cover
11 Left Cover
12 Rear Upper Cover Remove No.13.
13 Original Cover
14 Rear Cover
15 Connector Cover
16 Upper Right Door
(Multi Bypass
Unit)
17 Counter Cover
18 Right Cover
Remove No.3.
Remove No.3.
Remove four EDH Glass Holder mounting
screws.
Raise No.13. Swing down No.5.
No.11. Remove five Control Panel mounting screws.
two connectors.
Swing down the Front Door.
shafts. Remove two belt mounting screws inside the Front
Door.
Slide out the drawer.
Pressing the tab on the left rail, pull out the drawer.
Remove No.11. Remove two Middle Left Door mounting
screws.
D-23
Unhook one tab on the Filter Cover.
Slide out No.6. Swing down No.5.
mounting screws.
Remove No.11.
two Rear Upper Cover mounting screws.
Remove the Original Cover by pulling up.
Remove nine Rear Cover mounting screws.
Remove one Connector Cover mounting screws.
D-15
Unhook two tabs on the Counter Cover.
Slide out No.6. Swing down No.5.
Multi Bypass Table.
screws.
D-4
Removal Procedure
Remove No.18.
Remove two Front Door hinge
Remove one screw and the right stopper.
Remove seven Left Cover
Remove No.18.
Open No.16.
Remove seven Right Cover mounting
Remove
Unplug
Remove
Open the