Zoom (Fd - Minolta Di450 Service Manual

Hide thumbs Also See for Di450:

Table of Contents

(12) Zoom (FD)

Adjust to eliminate any difference in width between the original test pattern and a test pat-

This adjustment must be made when the Scanner Drive Cable has been replaced.

Adjustment Procedure

1. Call the Tech. Rep. mode to the screen.

2. Touch [Function].

3. Touch [Printer].

4. Touch [F12 Test Pattern].

5. Touch [F12-3 (64-dot checkered)].

6. Select the paper source loaded with A4 lengthwise or Letter lengthwise paper.

7. Press the Start key, and without any delay, press the Stop key to let the copier produce

a test pattern.

8. Go back to the Basic screen.

9. Place the test pattern on the Original Glass and

lower the Original Cover.

10. Make a copy in the full size (× 1.000) mode.

11. Measure width A on the original test pattern and

the copy of the test pattern and find any difference

between the two measurements.

If there is any difference, perform the following

adjustment steps.

Setting Range

0.990 to 1.010

Table of Contents