Minolta Di450 Service Manual page 156

Rev. 1.1/10.00
5. Lower the Electronic Document Handler.
6. Connect the Hookup Cord of the Electronic
Document Handler.
7. At the back of the Electronic Document
Handler, remove the Hinge Stopper (two
screws) shown, turn it through 180 degrees,
and then reinstall in position.
8. At the back of the Electronic Document
Handler, remove the Hinge Stopper (two
screws) shown and reinstall it according to
the following instructions.
Plate: Use the upper two screw holes.
Hinge: Use the upper two screw holes.
Check that the Electronic Document Handler
does not open more than 60 degrees.
I-27
Note
Di450 / Di550