Minolta Di450 Service Manual page 391

Setting Instructions
If width A on the test pattern is greater than the specifications, move the Edge Guide to the
rear.
If width A on the test pattern is smaller than the specifications, move the Edge Guide to the
front.
9. Press the Start key to let the copier produce a test pattern.
10. Check to see if width A on the test pattern is up to specifications.
If the width falls outside the specified range, move the Edge Guide as necessary and
check again.
11. Following the same procedures, make the adjustment for all drawers.
7. Slide out the drawer used as the paper source for
the test pattern and then loosen the seven screws
shown on the left.
4002D250AA
8. Watching the scale on the adjustment plate in the
drawer, move the Edge Guide.
4002D251AA
D-110