Rev. 1.1/10.00
8. Slide the Unit back into the machine.
9. Lift the Transport Unit Release Lever up.
10. Push the Cleaning Blade Pressure Plate,
which is marked with a red label, completely
into the copier.
11. Open the Left Upper Door.
12. Remove the screw and, holding the Fusing
Unit Knob, Slide the Fusing Unit out of the
copier.
13. Screw in the two Screws (front and rear)
alternately until they are completely
tightened.
Ensure that the Upper and Lower Fusing Rollers
are pressed together evenly at the front and rear
ends.
I-3
NOTE
Di450 / Di550