Installation - Minolta Di450 Service Manual

1.9.2

Installation

Di450 / Di550
1. Remove the Rear Cover (nine screws).
2. Remove the Left Cover (seven screws).
3. Secure the PWB-R to the metal bracket as
illustrated (four screws).
Screw 3x6 mm
Make sure that the PWB-R is mounted in the
correct direction.
4. Secure the HDD to the metal bracket as
illustrated (four screws).
Screw silver
Make sure that the HDD is mounted in the correct
direction.
5. Fit Edge Covers and Wiring Saddles at the
locations shown in the illustration, connect
Harness A to the PWB-R (PJ2R) and the
HDD (PJ75), and secure Harness A with the
Edge Covers and Wiring Saddles.
I-76
Note
Note
Rev. 1.1/10.00