(1)
Clearing Procedures
<Initialize>
1. Turn OFF the Power Switch.
2. With the circuit across pins of PJ2 closed, turn ON the Power Switch.
3. Open the circuit in about 5 seconds.
4. Check that the message "Initialize Completed" is displayed on the Touch Panel and
then touch the "OK" key.
<Memory Clear>
1. Turn OFF the Power Switch.
2. With the circuit across TP1 and TP3 closed, turn ON the Power Switch.
3. Open the circuit in about 5 seconds.
4. Check that the message "Memory Clear Completed" is displayed on the Touch Panel
and then touch the "OK" key.
NOTES:
• If the copier exhibits an erratic display or operation, reset and clear in the following order:
Initialize
Memory Clear.
• If Memory Clear has been performed, make settings of various functions once again.
(2)
Data/Conditions Cleared by Reset Switches/Pins
Clearing Method
Data Cleared
Misfeed display
Fusing/
Malfunction
display
Others
Erratic operation/display
Job/Image
User's Choice
Tech. Rep. Mode
Security Mode
: Cleared
–: Not cleared
Front Door
Open/Close
–
Optical
–
–
–
–
–
Trouble Reset
Switch S25
–
–
–
–
–
S-6
Memory
Initialize
Clear
PJ2
TP1
–
–
–
–