Loop Adjustment - Minolta Di450 Service Manual

Hide thumbs Also See for Di450:

Table of Contents

Loop Adjustment

Adjust so that a correct loop is formed at part A when paper is fed through.

Specification

Approx. 4.0 mm (visual)

This adjustment is to be made when any of the following symptoms occurs: variation in the

amount of print leading edge void, paper skew, folded edge, and misfeed.

Adjustment Procedure

3. Press the Start Key to let the copier take up and feed a sheet of paper and visually

check that a correct loop is formed at part A of the location shown below.

The loop length is too long

causing the paper to have

too much slack.

Loop Adjustment

1. Swing down the Front Door and fit the Front Door

Interlock Switch Actuating Jig.

2. Remove three screws and the Cover.

Do not remove the belt mounting screw on the cover.

A good length of loop is

formed as the paper moves

into the Synchronizing Roll-

Setting Range

No loop is formed causing

the paper to be taut.

Table of Contents