F8 Atdc Sensor - Minolta Di450 Service Manual

(3)

F8 ATDC Sensor

Make this adjustment after any of the following procedures have been performed:
• Developer replacement
• ATDC replacement
• Memory Clear
NOTE
Make this adjustment before running an F5 AIDC Sensor operation.
Adjustment Procedure
4. Turn the Power Switch ON.
5. Call the Tech. Rep. mode to the screen.
6. Touch [Function].
7. Touch [Printer].
8. Touch [F8 ATDC Sensor].
9. Press the Start Key to let the copier make the F8 ATDC Sensor. (It will run for about 4
minutes.)
NOTES
• Note that the press of the Start Key lets the ATDC Sensor Adjustment run automatically.
Run this function only after the developer has been changed, ATDC Sensor replaced.
• While the copier is in the adjustment cycle, the Start Key is lit up orange. The key turns
green as soon as the adjustment cycle is completed.
10. Call the Adjust mode to the screen.
11. Touch [Printer].
12. Touch [ATDC Control].
13. Write down the value for "Current" in the ATDC column on the Adjust Label.
1. Load the Developing Unit with fresh developer.
2. Install the Developing Unit in the copier.
3. Close the Front Door.
NOTE
Do not open and close the Front Door until the F8
ATDC Sensor operation is completed after the Power
Switch has been turned ON.
1134D051AA
D-87