Wago Din Rail; Table 11: Wago Din Rail; Table 12: Permissible Wago Carrier Rails When Using Xtr Pfc200 - WAGO 750-626/040-000 Manual

WAGO-I/O-SYSTEM 750 XTR
750-xxxx/0040-xxxx Design Notes /XTR
5.3.2

WAGO DIN Rail

WAGO carrier rails meet the electrical and mechanical requirements shown in the
table below.

Table 11: WAGO DIN Rail

Order number
210-112 /-113
210-197 /-114
210-118
210-198
210-196
Pos : 26.4 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/Bus klemmen 750xxxx/0040xxxx 4g-5g @ 15\mod_1367558844291_21.doc x @ 118470 @ @ 1
For vibration loads > 4g, observe the following installation instructions:
• Use pan-head screws or blind rivets at least every 60 mm (12 mm pin
spacing) to secure the DIN rail.
• Make the open conductor length between strain relief and wire connection
as short as possible.
• Use the reinforced end stop 249-197.
Pos : 26.5 /Serie 750 (WAGO-I/O-SYST EM)/M ontieren/D emontieren/Aus wahl der Tragsc hiene für XTR- PFC @ 23\mod_1435150387049_21.doc x @ 184498 @ @ 1
• When using the PFC200 CS 2ETH RS/XTR (750-8202/040-00x), carrier
rails without an oblong hole must also be used. Alternatively, a material
thickness of min. 1.5 mm must be maintained.
• When using the PFC200 CS 2ETH RS CAN DPS/XTR
(750-8206/040-00x), carrier rails without an oblong hole with a material
thickness of min. 2.3 mm must also be used.

Table 12: Permissible WAGO Carrier Rails When Using XTR PFC200

Item Number
210-113
210-114
210-197
210-118
Pos : 26.6 /Dokumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.2.0
Description
35 × 7.5; 1 mm; steel yellow chromated; slotted/unslotted
35 × 15; 1.5 mm; steel yellow chromated; slotted/unslotted
35 × 15; 2.3 mm; steel yellow chromated; unslotted
35 × 15; 2.3 mm; copper; unslotted
35 × 8.2; 1.6 mm; aluminum; unslotted
750-8202/040-00x 750-8206/040-00x
×
×
×
×
Assembly 25
–
–
–
×