The Lcd-Display - Danfoss FC 300 Programming Manual

How to Programme

2.1.2 The LCD-Display

The LCD-display has back light and a total of 6 alpha-numeric
lines. The display lines show the direction of rotation (arrow),
the chosen Set-up as well as the programming Set-up. The
display is divided into 3 sections:
Top section shows up to 2 measurements in normal operating
status.
The top line in the Middle section shows up to 5 measure-
ments with related unit, regardless of status (except in the
case of alarm/warning).
Bottom section always shows the state of the frequency
converter in Status mode.
The Active Set-up (selected as the Active Set-up in
par. 0-10 Active Set-up) is shown. When programming another
Set-up than the Active Set-up, the number of the programmed
Set-up appears to the right.
Display Contrast Adjustment
▲
Press [status] and [ ] for darker display
▼
Press [status] and [ ] for brighter display
Most parameter set-ups can be changed immediately via the
LCP, unless a password has been created via par. 0-60 Main
Menu Password or via par. 0-65 Quick Menu Password.
FC 300 Programming Guide
Indicator lights (LEDs):
If certain threshold values are exceeded, the alarm and/or
warning LED lights up. A status and alarm text appear on the
LCP.
The ON LED is activated when the frequency converter
receives mains voltage or via a DC bus terminal or 24 V
external supply. At the same time, the back light is on.
LCP Keys
The control keys are divided into functions. The keys below
the display and indicator lamps are used for parameter Set-up,
including choice of display indication during normal
operation.
[Status] indicates the status of the frequency converter and/or
the motor. You can choose between 3 different readouts by
pressing the [Status] key:
5 line readouts, 4 line readouts or Smart Logic Control.
Use [Status] for selecting the mode of display or for changing
back to Display mode from either the Quick Menu mode, the
Main Menu mode or Alarm mode. Also use the [Status] key to
toggle single or double read-out mode.
[Quick Menu] allows quick access to different Quick Menus
such as:
Use [Quick Menu] for programming the parameters belonging
to the Quick Menu. It is possible to switch directly between
Quick Menu mode and Main Menu mode.
[Main Menu] is used for programming all parameters.
®
MG.33.M9.02 - VLT is a registered Danfoss trademark
•
Green LED/On: Control section is working.
•
Yellow LED/Warn.: Indicates a warning.
•
Flashing Red LED/Alarm: Indicates an alarm.
On
Warn.
Alarm
•
My Personal Menu
•
Quick Set-up
•
Changes Made
•
Loggings
2 2
13