Danfoss FC 300 Programming Manual page 21

How to Programme
Status Mode: Displays the status of the frequency converter or
the motor.
If an alarm occurs the NLCP automatically switches to status
mode.
A number of alarms can be displayed.
NOTE
Parameter copy is not possible with LCP 101 Numerical
Local Control Panel.
FC 300 Programming Guide
Main Menu/ Quick Setup is used for programming all parame-
ters or only the parameters in the Quick Meny (see also
description of the LCP 102 earlier in this chapter).
The parameter values can be changed using the [
when the value is flashing.
Select Main Menu by pressing [Menu] key a number of times.
Select the par. group [xx-__] and press [OK]
Select the parameter [__-xx] and press [OK]
If the parameter is an array parameter select the array number
and press [OK]
Select the wanted data value and press [OK]
Parameters with functional choices display values such as [1],
[2], etc. For a description of the different choices, see the
individual description of the parameters in the Parameter
Selection section
[Back] for stepping backwards
Arrow [
commands and within parameters.
®
MG.33.M9.02 - VLT is a registered Danfoss trademark
▲ ▼
] [ ] keys are used for manoeuvring between
P 2-03
S ta tus Q uick
M enu S etup
▲ ▼
] [ ] keys
S etup 1
M ain
M enu
21
2 2