Danfoss FC 300 Programming Manual page 119

Parameter Descriptions
3.13.3 12-2* Process Data
12-20 Control Instance
Range: Function:
[None, 20, 21, 100, Read only. Displays the originator-to-target
101, 103] connection point. If no CIP connection is
present "None" is displayed.
12-21 Process Data Config Write
Range: Function:
[[0 - 9] PCD read 0 - 9] Configuration of readable process
data.
NOTE
For configuration of 2-word (32-bit) parameter read/
write, use 2 consecutive arrays in par. 12-21 and 12-22.
12-22 Process Data Config Read
Range: Function:
[[0 - 9] PCD read 0 - 9] Configuration of readable process
data.
12-28 Store Data Values
Option: Function:
This parameter activates a function that stores all
parameter values in the non-volatile memory
(EEPROM) thus retaining parameter values at
power-down.
The parameter returns to "Off".
[0] Off The store function is inactive.
*
[1] Store All All parameter value will be stored in the non-
set-ups volatile memory, in all four setups.
12-29 Store Always
Option: Function:
Activates function that will always store received
parameter data in non-volatile memory (EEPROM).
[0] Off
*
[1] On
FC 300 Programming Guide
3.13.4 12-3* EtherNet/IP
12-30 Warning Parameter
Range:
FFFF hex]
12-31 Net Reference
Option:
[0]
[1]
12-32 Net Control
Option:
[0]
[1]
12-33 CIP Revision
Option:
[0] Major version (00 - 99)
[1] Minor version (00 - 99)
12-34 CIP Product Code
Range:
1100 (FC 302) 1110 (FC
301)
®
MG.33.M9.02 - VLT is a registered Danfoss trademark
Function:
[0000 – Read only. Displays the EtherNet/IP specific 16-bit
Status-word.
Bit Description
0 Owned
1 Not used
2 Configured
3 Not used
4 Not used
5 Not used
6 Not used
7 Not used
8 Minor recoverable fault
9 Minor unrecoverable fault
10 Major recoverable fault
11 Major unrecoverable fault
12 Not used
13 Not used
14 Not used
15 Not used
Function:
Read only. Displays the reference source in Instance
21/71.
Off Reference from the network is not active.
*
On Reference from the network is active.
Function:
Read only. Displays the control source in Instance 21/71.
Off Control via the network is not active.
*
On Control via the network is active
Function:
Read only. Displays the CIP-version of
the option software.
[0 – 9999] Read only. Displays the CIP
*
Function:
product code.
119
3 3