Danfoss FC 300 Programming Manual page 9

Introduction
Input polarity of control terminals
NOTE
Control cables must be screened/armoured.
See section entitled Earthing of Screened/Armoured Control
Cables for the correct termination of control cables.
FC 300 Programming Guide
1.1.6 Start/Stop
Terminal 18 = par. 5-10 Terminal 18 Digital Input [8] Start
Terminal 27 = par. 5-12 Terminal 27 Digital Input [0] No
operation (Default coast inverse)
Terminal 37 = Safe stop (where available!)
®
MG.33.M9.02 - VLT is a registered Danfoss trademark
1 1
9