Main Menu Mode; Parameter Selection - Danfoss FC 300 Programming Manual

How to Programme

2.1.9 Main Menu Mode

Start the Main Menu mode by pressing the [Main Menu] key.
The read-out shown to the right appears on the display.
The middle and bottom sections on the display show a list of
par. groups which can be chosen by toggling the up and
down buttons.
Each parameter has a name and number which remain the
same regardless of the programming mode. In the Main Menu
mode, the parameters are divided into groups. The first digit
of the parameter number (from the left) indicates the par.
group number.
All parameters can be changed in the Main Menu. However,
depending on the choice of configuration (par. 1-00 Configu-
ration Mode), some parameters can be "missing". E.g. open
loop hides all the PID parameters, and other enabled options
make more par. groups visible.

2.1.10 Parameter Selection

In the Main menu mode, the parameters are divided into
groups. You select a par. group by means of the navigation
keys.
The following par. groups are accessible:
After selecting a par. group, choose a parameter by means of
the navigation keys.
The middle section on the display shows the parameter
number and name as well as the selected parameter value.
FC 300 Programming Guide
2.1.11 Changing Data
The procedure for changing data is the same whether you
select a parameter in the Quick menu or the Main menu
mode. Press [OK] to change the selected parameter.
The procedure for changing data depends on whether the
selected parameter represents a numerical data value or a text
value.
2.1.12 Changing a Text Value
If the selected parameter is a text value, change the text value
by means of the [
The up key increases the value, and the down key decreases
the value. Place the cursor on the value you want to save and
press [OK].
2.1.13 Changing a Group of Numeric Data
If the chosen parameter represents a numeric data value,
change the chosen data value by means of the [
tion keys as well as the [
navigation keys to move the cursor horizontally.
Use the [
up key enlarges the data value, and the down key reduces the
data value. Place the cursor on the value you want to save and
press [OK].
®
MG.33.M9.02 - VLT is a registered Danfoss trademark
▲ ▼
] [ ] navigation keys.
Values
▲ ▼
] [ ] navigation keys. Use the [
▲ ▼
] [ ] navigation keys to change the data value. The
2 2
◀ ▶
] [ ] naviga-
◀ ▶
] [ ]
19