Adjust Display Contrast; How To Connect A Pc To The Fc 300; The Fc 300 Software Dialogue - Danfoss VLT AutomationDrive FC 300 Operating Instructions Manual

FC 300 Operating Instructions

Adjust Display Contrast

Hold down [STATUS] and use the up or down navigation arrow to adjust the display contrast

How to Connect a PC to the FC 300

To control the frequency converter from a PC, install
the MCT 10 Set-up Software.
The PC is connected via a standard (host/device)
USB cable, or via the RS485 interface as shown in
the section Bus Connection in the chapter How to
Programme.

The FC 300 Software Dialogue

Data storage in PC via MCT 10 Set-Up Software:
Connect a PC to the unit via USB com port
1.
Open MCT 10 Set-up Software
2.
Choose "Read from drive"
3.
4. Choose "Save as"
All parameters are now stored.
30
How to Programme
USB connection.
Data transfer from PC to drive via MCT 10
Set-Up Software:
1.
2.
3.
4.
5.
All parameters are now transferred to the drive.
A separate manual for MCT 10 Set-up Software is
available.
MG.33.A2.02 - VLT is a registered Danfoss trademark
Connect a PC to the unit via USB com port
Open MCT 10 Set-up software
Choose "Open" – stored files will be shown
Open the appropriate file
Choose "Write to drive"