Danfoss FC 300 Programming Manual page 82

Parameter Descriptions
5-62 Pulse Output Max Freq #27
Range:
Application
dependent
*
3 3
5-63 Terminal 29 Pulse Output Variable
Option:
[0] No operation
*
[45] Bus ctrl.
[48] Bus ctrl., timeout
[51] MCO controlled
[100] Output frequency
[101] Reference
[102] Feedback
[103] Motor current
[104] Torque rel to limit
[105] Torq relate to rated
[106] Power
[107] Speed
[108] Torque
[109] Max Out Freq
[119] Torque % lim
5-65 Pulse Output Max Freq #29
Set the maximum frequency for terminal 29 corresponding to the
output variable set in par. 5-63 Terminal 29 Pulse Output Variable.
This parameter cannot be adjusted while the motor is running.
Range:
5000 Hz
*
5-66 Terminal X30/6 Pulse Output Variable
Select the variable for read-out on terminal X30/6.
This parameter cannot be adjusted while the motor is running.
This parameter is active when option module MCB 101 is installed
in the frequency converter.
Same options and functions as par. group 5-6*.
Option:
[0]
*
[45]
[48]
[51]
[100]
[101]
[102]
[103]
82
Function:
[0 - 32000 Set the maximum frequency for
Hz] terminal 27, corresponding to the
output variable selected in
par. 5-60 Terminal 27 Pulse Output
Variable.
This parameter cannot be adjusted
while the motor is running.
Function:
Select the desired display output for
terminal 29. This parameter is available
for FC 302 only.
This parameter cannot be adjusted
while the motor is running.
Function:
[0 - 32000 Hz]
Function:
No operation
Bus ctrl.
Bus ctrl., timeout
MCO controlled
Output frequency
Reference
Feedback
Motor current
MG.33.M9.02 - VLT
FC 300 Programming Guide
5-66 Terminal X30/6 Pulse Output Variable
Select the variable for read-out on terminal X30/6.
This parameter cannot be adjusted while the motor is running.
This parameter is active when option module MCB 101 is installed
in the frequency converter.
Same options and functions as par. group 5-6*.
Option:
[104]
[105]
[106]
[107]
[108]
[109]
[119]
5-68 Pulse Output Max Freq #X30/6
Select the maximum frequency on terminal X30/6 referring to the
output variable in par. 5-66 Terminal X30/6 Pulse Output Variable.
This parameter cannot be adjusted while the motor is running.
This parameter is active when option module MCB 101 is mounted
in the frequency converter.
Range:
Application depend-
ent
*
®
is a registered Danfoss trademark
Function:
Torque rel to limit
Torq relate to rated
Power
Speed
Torque
Max Out Freq
Torque % lim
Function:
[0 - 32000 Hz]