Display - Danfoss VLT 5000 Crane Series Operating Instructions Manual

Display

The LCD-display has back lighting and a total of
4 alpha-numeric lines including a box showing the
direction of rotation (arrow) and the chosen set-up as
well as the set-up in which programming is taking place.
1st line 12345678901234567890
12345678
2nd line
3rd line
12345678901234567890
12345678901234567890
4th line
1st line shows up to 3 measurements continuously in
normal operating status or a text explaining the 2nd line.
2nd line shows a measurement with related
unit continuously, regardless of status (except
in case of an alarm/warning).
3rd line is normally blank and is used in the
menu mode to show the selected parameter
group number and name
4th line is used in operating status for showing a
status text or in data change mode for showing the
mode or value of the selected parameter.
An arrow indicates the direction of the motor rotation.
LEDs
At the bottom of the control panel is a red alarm
LED, a yellow LED and a green voltage LED.
red
If certain threshold values are exceeded, the alarm
and/or warning LED lights up concurrently with a
status and alarm text on the control panel.
Display Read-Out State
The display read-out state can be varied - see the list
below - depending on whether the frequency converter
is in normal operation or is being programmed.
Display Mode
In normal operation, up to 4 different operating
variables can be indicated continuously: 1.1 and 1.2
and 1.3 and 2, and in line 4 the present operating
status or alarms and warnings that have arisen.
= factory setting. () = display text [] = value for use in communication via serial communication port
MG.50.N4.02 - VLT is a registered Danfoss trademark
SETUP
1
yellow green
VLT® 5000 Crane
VAR 1.1 VAR 1.2 VAR 1.3
VAR 2
STATUS
Display Mode - Selection of Read-Out State
There are three options in connection with the
choice of read-out state in the Display mode - I, II
and III. The choice of read-out state determines the
number of operating variables read out.
Read-out state: I:
Line 1 Description
for operating
variable in line 2
The table below gives the units linked to the variables
in the first and second line of the display.
SETUP
1
II: III:
Data value for Description for
3 operating 3 operating
variables in line variables in line
1 1
37