Questionable Status Group - Keysight Technologies N6705C Operating And Service Manual

7 SCPI Programming Reference
ORed into the OPERation summary bit (7) of the Status Byte register. Refer to
description of each register. The following table describes the bit assignments.
Bit Bit Name
0 CV
1 CC
2 OFF
3 not used
4 WTG-tran
5 MEAS-active
6 TRAN-active
7-15 not used

Questionable Status Group

These register groups record signals that indicate abnormal operation. The group consists of a
Condition, PTR/NTR, Event, and Enable register. The outputs of the Questionable Status group are
logically-ORed into the QUEStionable summary bit (3) of the Status Byte register. Refer to
Registers for a description of each register. The following table describes the bit assignments.
Bit Bit Name
0 OV
1 OC
2 PF
3 CP+
4 OT
5 CP–
6 OV–
7 LIM+
8 LIM–
9 INH
10 UNR
11 PROT
12 OSC
13-15 not used
350
Decimal Value
1 Output is in constant voltage
2 Output is in constant current
4 Output is programmed off
not used 0 is returned
16 Transient system is waiting or a trigger
32 Measurement system is initiated
64 Transient system is initiated
not used 0 is returned
Decimal
Value
1 Output is disabled by the over-voltage protection
2 Output is disabled by the over-current protection
4 Output is disabled by an AC power-fail (low-line or brownout)
8 Output is limited (or disabled) by the positive power limit
16 Over-temperature protection has tripped
32 Output is limited by the negative power limit
64 Negative over-voltage protection has tripped
128 Output is in positive voltage or current limit
256 Output is in negative voltage or current limit
512 Output is inhibited by an external INHibit signal
1024 Output is unregulated
2048 Output has been disabled because it is coupled to a protection condition that
occurred on another channel
4096 Oscillation detector has tripped
not used 0 is returned
Status Registers
Definition
Definition
Keysight N6705C Operating and Service Guide
for a
Status