Connecting The Power Cord - Keysight Technologies N6705C Operating And Service Manual

Connecting the Power Cord

FIRE HAZARD Use only the power cord that was supplied with your instrument. Using
other types of power cords may cause overheating of the power cord, resulting in fire.
SHOCK HAZARD The power cord provides a chassis ground through a third conductor.
Be certain that your power outlet is of the three-conductor type with the correct pin
connected to earth ground.
Connect the power cord to the IEC 320 connector on the rear of the unit. If the wrong power cord was
shipped with your unit, contact your nearest Keysight Sales and Support Office.
The AC input on the back of your unit is a universal AC input. It accepts nominal line voltages in the
range of 100 VAC to 240 VAC. The frequency can be 50 Hz, 60 Hz, or 400 Hz.
The detachable power cord may be used as an emergency disconnecting device.
Removing the power cord will disconnect AC input power to the unit.
Keysight N6705C Operating and Service Guide
2 Installation
55