3 Using the Source Functions
Step Parameters
Parameter
Start Setting (I 0 or V 0 )
End Setting (I 1 or V 1 )
Delay (T 0 )
From the remote interface:
The setting before the step:
ARB:CURR:STEP:STAR 0,(@1)
ARB:VOLT:STEP:STAR 0,(@1)
The setting after the step:
ARB:CURR:STEP:END 1,(@1)
ARB:VOLT:STEP:END 5,(@1)
The delay after the trigger is received before the step occurs:
ARB:CURR:STEP:STAR:TIM 0.01,(@1)
ARB:VOLT:STEP:STAR:TIM 0.01,(@1)
Trapezoid Parameters
116
Description
The setting before the step.
The setting after the step.
The delay after the trigger is received but before the step occurs.
Keysight N6705C Operating and Service Guide