Keysight Technologies N6705C Operating And Service Manual page 282

7 SCPI Programming Reference
FETCh[:SCALar]:CURRent:LOW? (@<chanlist>)
FETCh[:SCALar]:VOLTage:LOW? (@<chanlist>)
Returns the Low level of a pulse waveform. Values returned are either in amperes, or volts. See
Measurement Data Formats. The reading is in the form +n.nnnnnnE+nn for each channel specified.
Multiple responses are separated by commas.
Parameter
(none)
Returns the measured low level current FETC:CURR:LOW? (@1)
Returns the measured low level voltage FETC:VOLT:LOW? (@1)
FETCh[:SCALar]:CURRent:MAXimum? (@<chanlist>)
FETCh[:SCALar]:VOLTage:MAXimum? (@<chanlist>)
FETCh[:SCALar]:CURRent:MINimum? (@<chanlist>)
FETCh[:SCALar]:VOLTage:MINimum? (@<chanlist>)
Returns the maximum or minimum value. Values returned are either in amperes, or volts. See
Measurement Data Formats. The reading is in the form +n.nnnnnnE+nn for each channel specified.
Multiple responses are separated by commas.
Parameter
(none)
Returns the measured minimum current FETC:CURR:MIN? (@1)
Returns the measured minimum voltage FETC:VOLT:MIN? (@1)
Returns the measured maximum current FETC:CURR:MAX? (@1)
Returns the measured maximum voltage FETC:VOLT:MAX? (@1)
FETCh:ARRay:CURRent[:DC]? (@<chanlist>)
FETCh:ARRay:VOLTage[:DC]? (@<chanlist>)
FETCh:ARRay:POWer[:DC]? (@<chanlist>)
Returns an array with the instantaneous measurement. Values are either in amperes, volts, or watts.
The return format depends on the settings of the
When the data format is set to ASCII, returned values are comma separated. When the data format is
set to REAL, data is returned as single precision floating point values in definite length arbitrary block
response format.
282
Typical Return
<LOW value>
Typical Return
<MIN value>
<MAX value>
FORMat:BORDer and FORMat[:DATA]
Keysight N6705C Operating and Service Guide
commands.