Selection And Changing Of Parameters; Storing Parameter Value; Error Message - KEB COMBIVERT S4 Instruction Manual

7.3 Selection and
Changing of Para-
meters
Raising / decreasing
of parameter number
START
STOP
7.4 Storing Parameter
Value

7.5 Error Message

Display of
parameter number
START
ENTER FUNC.
F/R SPEED
STOP
When changing the value of an ENTER-Parameter a point appears
behind the last digit in the display. By pressing the ENTERkey the
adjusted value is accepted and stored (point disappears).
Example:
If an error occurs during operation the current display is overwritten by the
error message. To reset the error message press the key "ENTER".
Example:
The key ENTER only reset the error message. To reset
the error itself the error cause must be eliminated first
and a reset at terminal X2.2 or a cold start must be carried
out.
! Error Massages / Error Diagnosis see page GB 43!
Operation
When switching on the servo controller the
display always shows the value of parameter
CP.1 (Status Display).
Display of
parameter value
FUNC.
SPEED
START
ENTER FUNC.
F/R SPEED
STOP
ENTER
F/R
Acceptance /
Storing
Error /
Fault
Raising / decreasing
of parameter value
START
STOP
ENTER
F/R
GB 23
GB