Setting Terminal Emulation To Accept Tethered Laser Scanners - Intermec 6400 User Manual

Operation
stop bit with an ASCII STX (hex 02) before the data and an
ASCII ETX (hex 03) after the data. No protocols, such as
ACK/NAK, RTS/CTS, or XON/XOFF, are supported. All
8-bit characters between the STX and ETX will be stuffed
in the PC BIOS key buffer.
Setting Terminal Emulation to
Accept Tethered Laser Scanners
1. In AUTOEXEC.BAT, ensure the scanner driver is
2. From the Terminal Emulation mode, press the yellow
3. Select option 1) Set-up Parms.
4. Enter password CR52401.
5. Select option 2) Barcode Parms.
6. At Scanner Type menu select 3) Laser and press
7. At Main Menu select 4) Tests
8. At Tests menu select 1) Peripherals
9. At Peripherals menu select 5) Scanner Test
If you experience problems with using your laser scanner
with terminal emulation try these steps:
1. Reboot to the DOS prompt ([YELLOW] [BLUE]
2. Type DEL CONFIG.DAT press [ENT].
3. Press [CTRL] [ALT] [DEL] to reboot.
2-20 6400 Hand-Held Computer User's Guide
loaded with 64SCN7B --T1 --I0
and then the blue keys to enter the Terminal Emula-
tion Main Menu.
[ENT] five times.
[ENT] [ENT]) press 0 at pause.
SECTION 2