Reference Arm® Documentation; Swj Debug Port (Serial Wire And Jtag) - ST STM32F423 Reference Manual

RM0430
The Arm
comprised of:
•
SWJ-DP: Serial wire / JTAG debug port
•
AHP-AP: AHB access
•
ITM: Instrumentation trace macrocell
•
FPB: Flash patch breakpoint
•
DWT: Data watchpoint trigger
•
TPUI: Trace port unit interface (available on larger packages, where the corresponding
pins are mapped)
•
ETM: Embedded Trace Macrocell (available on larger packages, where the
corresponding pins are mapped)
It also includes debug features dedicated to the STM32F413/423:
• Flexible debug pinout assignment
•
MCU debug box (support for low-power modes, control over peripheral clocks, etc.)
Note: For further information on debug functionality supported by the Arm
core, refer to the Cortex
CoreSight Design Kit-r0p1 TRM (see
34.2 Reference Arm
•
Cortex
(see Related documents on page 1)
•
Arm
• Arm
34.3

SWJ debug port (serial wire and JTAG)

The STM32F413/423 core of the integrates the Serial Wire / JTAG Debug Port (SWJ-DP). It
is an Arm
SW-DP (2-pin) interface.
•
The JTAG Debug Port (JTAG-DP) provides a 5-pin standard JTAG interface to the
AHP-AP port.
•
The Serial Wire Debug Port (SW-DP) provides a 2-pin (clock + data) interface to the
AHP-AP port.
In the SWJ-DP, the two JTAG pins of the SW-DP are multiplexed with some of the five JTAG
pins of the JTAG-DP.
® ®
Cortex -M4 with FPU core provides integrated on-chip debug support. It is
ort
p
®
-M4 with FPU-r0p1 Technical Reference Manual and to the
®
documentation
®
-M4 with FPU r0p1 Technical Reference Manual (TRM)
®
Debug Interface V5
®
CoreSight Design Kit revision r0p1 Technical Reference Manual
®
standard CoreSight debug port that combines a JTAG-DP (5-pin) interface and a
Section 34.2: Reference Arm®
RM0430 Rev 8
Debug support (DBG)
® ®
Cortex -M4 with FPU
documentation).
1285/1324
1314