Powering Options - Lightware UMX-TPS-TX120 User Manual


  
3. Installation
3.6. Powering Options
A
A Using local PSU - connect the power adaptor to the DC input on the transmitter first, then to the AC
power socket.
Using PoE with connecting a transmitter: connect the TPS OUT (PoE) port of the transmitter to the
B
TPS+PoE port of the TPS-PI-1P1 power injector by a CATx cable, and connect the TPS input port of
the compatible receiver to the TPS port of the TPS-PI-1P1 by a CATx cable.
C Using PoE with connecting a matrix or an input board: connect the TPS OUT (PoE) port of the
transmitter to the PoE-compatible TPS input port of the matrix or input board by a CATx cable.
ATTENTION!
In case of connecting the transmitter to an input board of the matrix always connect an
external PSU to the board. For the detailed information please read the user's manual of the matrix.
ATTENTION!
The Ethernet port does not support PoE. Only the TPS port support PoE function.
B C
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual 37