Network; Front Panel - Lightware UMX-TPS-TX120 User Manual


  
5. Software Control - Lightware Device Controller
5.11.2. Network
Network tab in Settings menu
General
IP address and DHCP settings can be set on this tab. Always press the Apply settings button to save changes.
Factory defaults settings can be recalled with a dedicated button.
TCP/IP Ports and Services

DIFFERENCE: This feature is available only in UMX-TPS-TX140K and TX140-Plus models from FW
package v1.5.0b4.
The IP Port Block feature is an additional protection for the Cleartext login, see the
Settings) section. There are TCP/IP ports in Lightware devices which are not protected by the login, so you
can disable them if necessary. For example, due to the working method of the LW2 communication, the
Cleartext login does not provide protection when LW2 command is sent to the device, that is why the TCP
port no.10001 shall be blocked manually.
Cleartext Login (Login
#dhcp #ipaddress #network #portblock
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
MAC Filter Allowlist

DIFFERENCE: This feature is available only in UMX-TPS-TX140K and TX140-Plus models from FW
package v1.5.0b4.
Another level of the security is the MAC Filtering tool. You can create a list of network devices based on the
MAC address which are allowed:
Controlling the device (Send option), or
▪
▪ Querying parameters (Receive option) to/from the Lightware device.
Do not forget to press the Apply changes button to store the new settings.

ATTENTION! The first three lines are factory default values and they are necessary for the proper working.

ATTENTION! If the device is installed in a network where it gets IP address from a DHCP server and you
plan to use the MAC filtering, make sure the MAC address of the DHCP server is added to the white list.
Otherwise, the device will not get IP address and will be unreachable.
5.11.3. Front Panel
Front panel operation LEDs and buttons can be configure in this tab.
▪ You can disable the functionality of the front panel buttons with marking the Lock front panel option.
This is same method of the control lock made by the front panel buttons. See the details in the
Lock section. #controllock #buttonlock #lockbutton
▪ Dark mode enable/disable: video and audio LEDs on the front panel are turned off 60 seconds after
enabling the dark mode.
Enable default function for Video Select / Audio Select / Function (Show me) button: when this property is
▪
disabled, it means that pushing the button will not perform the original function. This makes the
button free for programming custom function by the
LW3 protocol, for more details see the
#macfilter
Front panel tab in the Settings menu
#darkmode
Event Manager. This setting is also available via
Disable the Default Function of the Front Panel Buttons
79
Control
section.