Features; List Of Features (In Alphabetical Order) - Lightware UMX-TPS-TX120 User Manual

Hdbaset multimedia extender
Hide thumbs Also See for UMX-TPS-TX120:
Table of Contents

Advertisement

 
1. Introduction
1.3. Features

ATTENTION!
The availability of below features are device-dependent, see the following page.
1.3.1. List of Features (in alphabetical order)
4K and 3D Support
High bandwidth allows extension of resolutions up to 4K and even 3D sources and displays are
supported.
Autoselect Function for Video Inputs
The Autoselect feature can sense the port status on the video input ports and select
automatically one of them. Various modes are available: first detect, last detect, priority detect.
Basic IT-security
LWR
These entry-level network security improvements help to prevent unauthorized access to the
Lightware device: plain-text login, TCP port blocking and MAC address filtering.
Batch Commands
A batch of LW3 commands (salvo) can be run by the Lightware device either by a previously
stored macro or by sending a file to the device with the desired commands.
Breakaway Audio/Video Switching
Breakaway audio/video switching allows for switching audio and video separately by de-
embedding and embedding audio from/into HDMI signals.
Consumer Electronics Control
CEC
Supports transmitting standard CEC commands in order to remote control the source or sink
device.
Dark Mode
All illuminating elements of the front/rear panel can be switched on and off. This feature is
useful in live-stage shows or other environments where flashing LEDs would be distracting.
Deep Color Support and Conversion
It is possible to transmit the highest quality 36-bit video streams for perfect color reproduction.
Event Manager
The Event Manager tool takes care of all the necessary control in a smaller configuration by
performing predefined actions in response to device status changes.
Event Manager +
Triggering a condition, defining variables and checking two conditions for an action – these
features are available by the improved Event Manager.
Forced Button Lock
The front panel buttons can be locked and unlock is only possible via LW3 protocol command.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
GPIO Control Port
7 GPIO pins operating at TTL digital signal levels and can be controlled with both LW2 and LW3
commands.
HDCP-compliant
The device fulfills the HDCP standard. HDCP capability on the digital video inputs can be
disabled when non-protected content is extended.
Infra Code Sending
IR code sending in Pronto Hex format – in Command injection mode, too. The code sending is
available as an Action in Event manager, too.
Miniweb
The Miniweb is able to display an adaptive surface with a virtual crosspoint and buttons for
Event manager Actions. The miniweb can be displayed in a mobile device, too.
Pixel Accurate Reclocking
Each output has a clean, jitter free signal, eliminating signal instability and distortion caused by
long cables or connector reflections.
Remote Power
The transmitters are PoE-compatible and can be powered locally by the supplied power
adaptor, or remotely via the TPS connection with a compatible power source equipment.
RS-232 Recognizer
RS-232
x
Support recognizing incoming RS-232 messages to integrate with 3rd party devices like the
11 0100 1
videoconference codec devices.
RS-232 Transmission
RS-232
AV systems can also contain serial port controllers and controlled devices. Serial port pass-
through supports any unit that works with standard RS-232.
Signal Transmission up to 170 m
Video and audio signal transmission (HDMI, Ethernet, RS-232, and Infra-Red) over a single
CAT5e...CAT7e cable.
TCP Recognizer
TCP
x
Support recognizing the incoming TCP messages to integrate with 3rd party devices like the
11 0100 1
videoconference codec devices.
TPS Cable Diagnostic Tool
The TPS Cable Diagnostics Tool within the LDC software will help you identify potential twisted
pair cable issues in your TPS-capable (HDBaseT compliant) system.
USB Extension
KVM extension for USB HID devices (Human Interface Devices, e.g. keyboard, mouse,
presenter).
11

Advertisement

Table of Contents
loading

This manual is also suitable for:

Umx-tps-tx130Umx-tps-tx140Umx-tps-tx140kUmx-tps-tx140-plusFp-umx-tps-tx120Fp-umx-tps-tx130 ... Show all

Table of Contents