Change The Audio Autoselect Mode; Change The Video Input Priorities; Change The Audio Input Priorities - Lightware UMX-TPS-TX120 User Manual


  
6. LW2 Programmer's Reference
6.4.9. Change the Audio Autoselect Mode
The autoselect mode of the audio output can be changed.
Command and Response
ȩ {AS_A<out>=<state>;<mode>}
Ȩ (AS_A<out>=<state>;<mode>)CrLf
Parameters
See the previous section.
Example
ȩ {as_a1=E;P}
Ȩ (AS_A1=E;P)
The Autoselect mode of audio output1 is enabled and set to Priority mode.

INFO: The Autoselect mode can be queried by typing the {as_a<out>=?} command.
6.4.10. Change the Video Input Priorities
The settings of video input priority can be changed as follows.
Command and Response
ȩ {PRIO_V<out>=<in1_prio>;<in2_prio>;...;<inn_prio>}
Ȩ (PRIO_V<out>=<in1_prio>;<in2_prio>;...;<inn_prio>)CrLf
Parameters
Parameter Parameter description
<in1_prio> Priority number of the input
<in2_prio> ports
<inn_prio>
See more details about port numbering in the
Example
ȩ {prio_v1=1;0;2;3}
Ȩ (PRIO_V1=1;0;2;3)

ATTENTION! Always set all the priority of the ports when changing, otherwise, the change will not be
executed and the response will be the current setting (like querying the priority setting).

INFO: The video priorities can be queried by typing the {prio_v<out>=?} command.
Value Value description
0: highest priority
0-5,
5: lowest priority
31
31: skip the port from the priority list
Port Numbering section.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
6.4.11. Change the Audio Input Priorities
The settings of audio input priority can be changed as follows.
Command and Response
ȩ {PRIO_A<out>=<in1_prio>;<in2_prio>;...;<inn_prio>}
Ȩ (PRIO_A<out>=<in1_prio>;<in2_prio>;...;<inn_prio>)CrLf
Parameters
See the previous section.
Example
ȩ {prio_a1=1;0;2}
Ȩ (PRIO_A1=1;0;2)
Input 2 has the highest priority (0), Input 1 has the second highest (1). Input 3 has the lowest priority (2).

ATTENTION! Always set all the priority of the ports when changing, otherwise, the change will not be
executed and the response will be the current setting (like querying the priority setting).

INFO: The audio priorities can be queried by typing the {prio_a<out>=?} command.
92