Sending Cec Commands In Hex Format; Querying The Last Received Cec Message; Infrared Port Configuration; Enable Command Injection Mode - Lightware UMX-TPS-TX120 User Manual


  
7. LW3 Programmers' Reference
7.20.4. Sending CEC Commands in Hex Format
ç CALL·/MEDIA/CEC/<port>:sendHex(<hex_code>)
æ mO·/MEDIA/CEC/<port>:sendHex
Parameters
Parameter Parameter description
<port> Video input or video output
port
<hex_code> The desired CEC command
Example
ç CALL /MEDIA/CEC/I2:sendHex(8700E091)
æ mO /MEDIA/CEC/I2:sendHex
7.20.5. Querying the Last Received CEC Message
ç GET /MEDIA/CEC/<port>.LastReceivedMessage
æ pr /MEDIA/CEC/<port>.LastReceivedMessage=<CEC_message>
Parameters
Parameter Parameter description
<port> Video port
<CEC_message> The last incoming CEC message
from the connected device.
Example
ç GET /MEDIA/CEC/I2.LastReceivedMessage
æ pr /MEDIA/CEC/I2.LastReceivedMessage=give_power_status
TIPS AND TRICKS:
This property can be a condition in the Event manager. When the connected device
sends status information via CEC, it could be a trigger for an action.
Values Value description
Video inputs
I1-I4
O1-O2 Video outputs
Max. 30 character (15 byte) in hexadecimal format.
Values Value description
I1-I4 or
O1-O2
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
7.21. Infrared Port Configuration
INFO:
Infrared input and output port numbering can be found in the
7.21.1. Enable Command Injection Mode
Command and Response #commandinjection
ç SET·/MEDIA/IR/<port>.CommandInjectionEnable=true|false
æ pw·/MEDIA/IR/<port>.CommandInjectionEnable=true|false
Example
ç SET /MEDIA/IR/S1.CommandInjectionEnable=true
æ pw /MEDIA/IR/S1.CommandInjectionEnable=true
7.21.2. Enable/Disable Output Signal Modulation
Command and Response
ç SET·/MEDIA/IR/<port>.EnableModulation=true|false
æ pw·/MEDIA/IR/<port>.EnableModulation=true|false
Example
ç SET /MEDIA/IR/D1.EnableModulation=false
æ pw /MEDIA/IR/D1.EnableModulation=false
Signal modulation is turned off on IR output (D1).

INFO: The default setting value is "true" (enabled).
137
Port Numbering section.