Front View - Fp-Umx-Tps-Tx100 Series - Lightware UMX-TPS-TX120 User Manual


  
2. Product Overview
2.5. Front View - FP-UMX-TPS-TX100 series
FP-UMX-TPS-TX120
2
3
4
5
6
FP-UMX-TPS-TX130
2
3
4
5
6
1
7
8
9
q
1
7
8
9
q
w
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
Input Status LEDs
1
2 Audio Select button
Video Select button
3
4 Ethernet
VGA input
5
Audio input
6
Show Me button
7
8 Reset button
9 IR detector
HDMI input
q
DisplayPort input
w
#analogaudio #audio #button #crosspoint #switch #testpattern #network #dhcp #reset reboot
#restart #nosyncscreen
LEDs give feedback about the current status of the unit and input signals. See
the details in the Front Panel LEDs section. #status
Button for switching between audio sources. See the details in the
Button section.
Button for switching between video sources. See the details in the
Button section.
Locking RJ-45 connector for configuring the device using Lightware Device
Controller (LDC), or updating it using Lightware Device Updater (LDU). Any
third-party control system can use this port to control the device.
D-SUB connector for analog video signal.
3.5 mm Jack connector for asymmetric analog audio input signal.
Special functions can be reached using this button (firmware update
(bootload) mode, DHCP settings, restore factory default settings, condition
launching in Event Manager).
Pushing the button reboots the unit.
IR Detector can sense IR light which can be forwarded to the receiver side or
use for controlling functions.
HDMI connector for DVI video or HDMI video and audio.
DisplayPort connector for DisplayPort audio/video signal.
19
Audio Select
Video Select