Connecting Steps; Powering Options - Lightware HDMI-TPS-TX210 User Manual

   
3. Installation
3.3. Connecting Steps
CATx Connect the the transmitter and a compatible receiver or the matrix input board by a CATx cable
viatheTPSconnectors.
DVI ConnectthetransmitterandthesourcesusingtheinputsandDVI-I/HDMI/DisplayPortcables.
HDMI
DP
Audio Optionallyconnectanasymmetricaudiodevicewithunbalancedaudiosignal(e.g.aMP3
player)tothe2.5"TRS(Jack)audioinputport.
IR OptionallyforInfraredcontrol:
-ConnecttheIRemittertotheIROUTportofthedevice.
-ConnecttheIRdetectortotheIRINportofthedevice.
LAN
OptionallyconnectthetransmittertoaLANnetworkinordertocontrolthedevice.
RS-232 OptionallyforRS-232control:connectacontroller/controlleddevice(e.g.touchpanel)tothe
RS-232port.
GPIO Optionallyconnectacontroller/controlleddevice(e.g.relaybox)totheGPIOport.
Power
Seepoweringoptionsinthenextsection.
HDMI-TPS-TX200series–User'sManual
3.4. Powering Options
A
B
C

ATTENTION!
externalPSUtotheboard.Forthedetailedinformationpleasereadtheuser'smanualofthematrix.

ATTENTION!

INFO:
Appliedfirmwarepackage:v1.2.0 | LDCsoftware:v2.2.0
Using local PSU:connectthepoweradaptortotheDCinputonthetransmitterfirst,thentotheAC
power socket.
Using PoE with connecting a transmitter:connecttheTPSOUT(PoE)portofthetransmittertothe
TPS+PoEportoftheTPS-PI-1P1powerinjectorbyaCATxcable,andconnecttheTPSinputportof
thecompatiblereceivertotheTPSportoftheTPS-PI-1P1byaCATxcable.
Using PoE with connecting a matrix or an input board:connecttheTPSOUT(PoE)portofthe
transmittertothePoE-compatibleTPSinputportofthematrixorinputboardbyaCATxcable.
In case of connecting the transmitter to an input board of the matrix always connect an
TheEthernetportdoesnotsupportPoE.OnlytheTPSportsupportPoEfunction.
If both remote and local power sources are connected, the remote power will be used.
21