Ethernet - Lightware UMX-TPS-TX120 User Manual


  
5. Software Control - Lightware Device Controller
5.9.4. Ethernet
Ethernet Tab in the Control Menu
Two ports are displayed in the Ethernet settings: Local, CPU, and TPS. You can check the status of the
Ethernet line by each ports: the speed and the duplexity of the connection.
The following settings are available for the local port:
Enable / disable the port;
▪
Reloading factory defaults.
▪

ATTENTION! If the Ethernet port is set to disabled, this may break the connection with the device.
INFO:
CPU Ethernet port cannot be disabled.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
HTTP Clients (HTTP Post and Put Message Sending)

DIFFERENCE: This feature is available only in UMX-TPS-TX140K and TX140-Plus models from FW
package v1.5.0b4.

ATTENTION! This feature means posting or putting HTTP messages from the Lightware device to another
device. Encrypted transmission (HTTPS) is not supported.
The HTTP Clients tab allows sending HTTP post and put messages to the desired server IP:port no. Control
commands can be set to the target device, but it is not suitable for processing the response (e.g. querying a
parameter/status) since the response is just an acknowledge (ACK).
The feature is available also by LW3 commands, see the
When you press the enter in the Http header or Http body text box, the \r\n is added automatically.
#http
HTTP Messaging section.
HTTP Clients tab in the Control/Ethernet menu
67