Rear View - Fp-Umx-Tps-Tx100 Series; Front Panel Leds - Lightware UMX-TPS-TX120 User Manual


  
2. Product Overview
2.5.1. Rear View - FP-UMX-TPS-TX100 series
1
TPS output (PoE) Locking RJ45 connector for HDBaseT
1
cable distances can be found in the
2 RS-232 connector 3-pole Phoenix connector for controlling the device with LDC or third-party
control systems, or third-party device control. Pin assignment can be found in
the RS-232 Connector
3 48V DC input Power the device remotely by a PoE-compatible power injector (TPS-PI-1P1).
If the device has to be powered by a local adaptor (PSU-48VP1), connect the
output to the 2-pole Phoenix connector on the rear of the floor plate. See more
details about powering options in the
the available
2 3
signal transmission. Maximum CATx
TM
Maximum Extension Distances
section.
48V DC Connection section or see all
Powering Options.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
2.6. Front Panel LEDs
INFO:
The operation of the status LEDs of WP-UMX-TPS-TX100 series and FP-UMX-TPS-TX100 series
models are the same.
ATTENTION!
When Dark mode is enabled, no LEDs are on, even though the device is fully functional.
#status
VIDEO input LEDs
green blinking
green on
AUDIO input LEDs
green blinking
green on (with short pause)
section.
green on (continuously)
Autoselect LED
green blinking
green on
HDCP LED
red
off Video source is not selected.
Video source is selected and signal is not detected.
Video source is selected and signal is present.
off Audio source is not selected.
Audio source is selected and signal is not detected.
Audio source is selected and the port is active but not embedded
to the output video stream (DVI output mode).
Audio source is selected, the port is active and the audio is
embedded to the output video stream (HDMI output mode).
off Autoselect function is disabled.
Autoselect function is enabled, searching for signal (the video
input LEDs are also blinking).
Autoselect function is enabled, the active video signal is found
(the selected video input's LED is also ON).
off Video output signal is not encrypted with HDCP.
on Video output signal is HDCP-encrypted.
20