Advanced View Window - Lightware UMX-TPS-TX120 User Manual


  
5. Software Control - Lightware Device Controller
5.14. Advanced View Window
1
6
7
#advancedview #terminal
2 3 4
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
LW3 protocol help
1
Protocol tree
2
Edit mode
3
Warning mode
4
Node list
5 5
6 Terminal window
7 Command line
Pushing the button results a help window opening which describes the most
important information about LW3 protocol commands in HTML format.
LW3 protocol tree; select an item to see its content.
The default appearance is the read-only mode. If you want to modify the
values or parameters, tick the option. You will be prompted to confirm your
selection.
If this is checked, a warning window pops up when you enable Edit mode.
Correspondent parameters and nodes are shown which are connected to the
selected item in the protocol tree. The commands typed in these fields are
escaped automatically
Manual button: Manual (short description) of the node can be called and
displayed in the terminal window.
Set button: Saves the value/parameter typed in the textbox.
Call button: Calls the method, e.g. reloads factory default settings.
Commands and responses with time and date are listed in this window. Sent
command starts with '>' character, received response starts with '<' character.
The color of each item depends on the type of the command and response.
The content of the window can be emptied by the Clear button. If the Autoscroll
option is ticked, the list is scrolled automatically when a new line is added.
The commands typed in this line are not escaped automatically. See more
information in the Escaping section.
85