Query The Status Of Destination Port; Query The Audio Crosspoint Setting; Switching Audio Input; Query The Audio Autoselect Settings - Lightware UMX-TPS-TX120 User Manual


  
7. LW3 Programmers' Reference
7.7.2. Query the Status of Destination Port
Command and Response
ç GET·/MEDIA/AUDIO/XP.DestinationPortStatus
pr·/MEDIA/AUDIO/XP.DestinationPortStatus=<out1_state>
æ
The response contains 5 ASCII characters for each port. The first character indicates the mute/lock state,
the next 2-byte long HEX code showing the current state of the output port.
Example
ç GET /MEDIA/AUDIO/XP.DestinationPortStatus
æ pr /MEDIA/AUDIO/XP.DestinationPortStatus=T000F
Legend
See at previous section.
Example and Explanation
T 0
0 0 0 0 0 0
Unlocked,
Unmuted
Reserved Reserved Reserved
7.7.3. Query the Audio Crosspoint Setting
Command and Response
ç GET·/MEDIA/AUDIO/XP.DestinationConnectionList
pr·/MEDIA/AUDIO/XP.DestinationConnectionList=<in>
æ
Example
ç GET /MEDIA/AUDIO/XP.DestinationConnectionList
æ pr /MEDIA/AUDIO/XP.DestinationConnectionList=I5
I5 input port is connected to the output port.
7.7.4. Switching Audio Input
Command and Response #audio
ç CALL·/MEDIA/AUDIO/XP:switch(<in>:<out>)
æ mO·/MEDIA/AUDIO/XP:switch
Example
ç CALL /MEDIA/AUDIO/XP:switch(I2:O1)
æ mO /MEDIA/AUDIO/XP:switch
0 0
0 0 0 0 0 0 1 1
Signal
Reserved Reserved Reserved
presents
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
7.7.5. Query the Audio Autoselect Settings
Command and Response
ç GET·/MEDIA/AUDIO/XP.DestinationPortAutoselect
pr·/MEDIA/AUDIO/XP.DestinationPortAutoselect=<out_set>
æ
The response shows the settings of each output one by one.
Parameters
Identifier
<out_set>
F
1 1
Connected
Example
ç GET /MEDIA/AUDIO/XP.DestinationPortAutoselect
æ pr /MEDIA/AUDIO/XP.DestinationPortAutoselect=EL
Explanation
EL: the Autoselect is Enabled on output, selected mode is Last detect.
INFO:
For more information about the Autoselect feature see
Parameter description Value
Two-letter code of the
E Autoselect is enabled.
Autoselect settings
D Autoselect is disabled.
1 letter
st
F First detect: the first active audio input is selected.
Priority detect: always the highest priority active
P
audio input will be selected.
Two-letter code of the
Autoselect settings
Last detect: always the last attached input is
L
2 letter
nd
switched to the output automatically.
Static: the audio input follows the selected video
S
if the video signal contains embedded audio.
The Autoselect Feature
112
Parameter value
section.