Front View - Wp-Umx-Tps-Tx100 Series; Rear View - Wp-Umx-Tps-Tx100 Series - Lightware UMX-TPS-TX120 User Manual


  
2. Product Overview
2.3. Front View - WP-UMX-TPS-TX100 series
WP-UMX-TPS-TX120-US
1
2
3
4
5
6
1 Input Status LEDs LEDs give feedback about the current status of the unit and input signals.
See the details in the
Audio Select button Button for switching between audio sources. See the details in the
2
Select Button
Video Select button Button for switching between video sources. See the details in the
3
Select Button
Ethernet Locking RJ-45 connector for configuring the device using Lightware
4
Device Controller (LDC), or updating it using Lightware Device Updater
(LDU). Any third-party control system can use this port to control the
device.
VGA input D-SUB connector for analog video signal.
5
6 Audio input 3.5 mm Jack connector for asymmetric analog audio input signal.
Show Me button Special functions can be reached using this button (firmware update
7
(bootload) mode, DHCP settings, restore factory default settings,
condition launching in
Reset button Pushing the button reboots the unit.
8
9 IR detector IR Detector can sense IR light which can be forwarded to the receiver
side or use for controlling functions.
q HDMI input HDMI connector for DVI video or HDMI video and audio.
w DisplayPort input DisplayPort connector for DisplayPort audio/video signal.
WP-UMX-TPS-TX130-US / WP-UMX-TPS-TX130-Plus-US
1
7 2
3
8
4
9
5
q
6
Front Panel LEDs section.
section. #audio #analogaudio
section. #crosspoint #switch
Event Manager). #dhcp #factorydefault
#reboot #reset
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
2.4. Rear View - WP-UMX-TPS-TX100 series
WP-UMX-TPS-TX120-US / WP-UMX-TPS-TX130-US /
WP-UMX-TPS-TX130-Plus-US
7
8
9
q
w
Audio
1 RS-232 connector
Video
2 TPS output (PoE)
3 48V DC input
1
3
2
3-pole Phoenix connector for controlling the device with LDC or third-party
control systems, or third-party device control. Pin assignment can be found
in the RS-232 Connector section.
Locking RJ45 connector for HDBaseT signal transmission. Maximum
TM
CATx cable distances can be found in the Maximum Extension Distances
section.
Power the device remotely by a PoE-compatible power injector (TPS-PI-
1P1). If the device has to be powered by a local adaptor (PSU-48VP1),
connect the output to the 2-pole Phoenix connector on the rear of the wall
plate. See more details about powering options in the
section or see all the available Powering Options.
18
48V DC Connection