Command Line Interface (Cli); How To Run - Lightware UMX-TPS-TX120 User Manual


  
8. Firmware Update
Step 4. Start the update and wait until it is finished.
Click on the Start Update button to start the procedure. The status is shown in
percent in the right side of the device line and the overall process in the bottom
progress bar.
If the Cleartext login is enabled and you did not enter the password in the Parameters window (or it is incorrect)
a window will appear to get the password at each device.

INFO: The device might reboot during the firmware update procedure.
The log about the updating process can be displayed in a new window by pressing the
progress bar reaches 100% (Done is displayed at all devices), the update of all devices are finished successfully
and a message appears; you can close the software.
Step 5. Wait until the unit reboots with the new firmware.
Once the firmware update procedure is completed, the device is rebooted with the new firmware. Shutting
down and restarting the device is recommended.
START UPDATE

button. When the
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
8.5. Command Line Interface (CLI)
DIFFERENCE:
The Command Line Interface is available from LDU2 v2.9.0b9.
The CLI of the LDU2 software is a simple tool for creating scriptable device updates without the need of
human interactions. It allows batch updating with the same features which are available in case of GUI
usage. #new
8.5.1. How to Run
Running under Windows OS
®
The installer of LDU2 puts the following file into the installation folder:
LightwareDeviceUpdaterV2_CLI.cmd
CLI is available by this file, the exe is not suitable for that purpose. Open a command line window to execute
or test the features directly.
Step 1. Open an Explorer window where the cmd file is located, the default is:
c:\Program Files (x86)\Lightware\Lightware Device Updater V2\LightwareDeviceUpdaterV2_CLI.
cmd.
Step 2. Click on the address line (highlighed with blue in the picture), type cmd.exe and press enter. The
command interpreter window of Windows is opened at the path of the LDU2 install folder.
Step 3. Now you can use the LightwareDeviceUpdaterV2_CLI.cmd file with the commands and options which
are described in the coming sections:
Running under Linux
The Command Line Interface under Linux Operating Systems can be run by the following:
LightwareDeviceUpdaterV2.sh
Runing an update:
bash LightwareDeviceUpdaterV2.sh update --ip 172.24.5.27 --package ~/Downloads/tps-
tx200_1.3.1b3.lfp2
The commands and options are the same under Windows
examples with LightwareDeviceUpdaterV2_CLI.cmd.
152
and Linux, too. Following sections contain
®