View Serial Number; View Installed Board; View Firmware For All Controllers; Query Health Status - Lightware UMX-TPS-TX120 User Manual


  
6. LW2 Programmer's Reference
6.3.8. View Serial Number
The device responds its 8-digit serial number.
Command and Response #serialnumber
ȩ {S}
Ȩ (SN:<SERIAL_N>)CrLf
Example
ȩ {s}
Ȩ (SN:5A004254)
The serial number structure can be found in the
6.3.9. View Installed Board
Shows the hardware name and revision of the installed cards.
Command and Response
ȩ {IS}
Ȩ (SL#·0·<MB_DESC>)CrLf
Ȩ (SL·END)CrLf
Example
ȩ {is}
Ȩ (SL# 0 UMX-TPS-TX140K)
Ȩ (SL END)
The device reports its motherboard (slot 0).
6.3.10. View Firmware for All Controllers
Shows the firmware versions of all installed controllers.
Command and Response
ȩ {FC}
Ȩ (CF·<DESC>)CrLf
Ȩ (CF·<DESC>)CrLf
Ȩ ...
Ȩ (CF END)CrLf
Example
ȩ {fc}
Ȩ (CF UMX-TPS-TX140K 1.5.0b1 r53)
Ȩ (CF END)
The device has one control panel.
About the Serial Number section.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
6.3.11. Query Health Status
Internal voltages and measured temperature values are shown.
Command and Response #status
ȩ {ST}
Ȩ (ST·<DESC>)CrLf
Example
ȩ {st}
Ȩ (ST CPU 12.16V 5.03V 3.30V 3.33V 3.37V 1.30V 1.86V 1.00V 53.22C 53.26C)
6.3.12. Restart the Device
The device can be restarted without unplugging power.
Command and Response #reboot #restart
ȩ {RST}
Ȩ
Example
ȩ {rst}
Ȩ
The device reboots; no response is sent in this case.
6.3.13. Restore Factory Default Settings
Settings can be reset to factory default values as follows:
Command and Response
ȩ {FACTORY=ALL}
Ȩ (FACTORY ALL...)CrLf
Example
ȩ {factory=all}
Ȩ (FACTORY ALL...).
All settings and parameters are reset to factory default, see the table in the
#factory
89
Factory Default Settings section.