Lw2 Commands - Quick Summary - Lightware UMX-TPS-TX120 User Manual


  
6. LW2 Programmer's Reference
6.8. LW2 Commands – Quick Summary
General LW2 Commands
List of All Available LW2 Commands
ȩ {lcmd}
View Product Type
ȩ {i}
Device Label Query
ȩ {label}
Query Control Protocol
ȩ {P_?}
View Firmware Version of the CPU
ȩ {F}
Connection Test
ȩ {PING}
Compile Time
ȩ {CT}
View Serial Number
ȩ {S}
View Installed Board
ȩ {IS}
View Firmware for All Controllers
ȩ {FC}
Query Health Status
ȩ {ST}
Restart the Device
ȩ {RST}
Restore Factory Default Settings
ȩ {FACTORY=ALL}
AV Port Settings
Switch an Input to the Outputs
ȩ {<in>@<out>•<layer>}
Mute Output
ȩ {#<out>•<layer>}
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
Unmute Output
ȩ {+<out>•<layer>}
Lock Output
ȩ {#><out>•<layer>}
Unlock Output
ȩ {+<<out>•<layer>}
View Connection State on the Output
ȩ {VC•<layer>}
View Crosspoint Size
ȩ {getsize•<layer>}
Change the Video Autoselect Mode
ȩ {AS_V<out>=<state>;<mode>}
Change the Audio Autoselect Mode
ȩ {AS_A<out>=<state>;<mode>}
Change the Video Input Priorities
ȩ {PRIO_V<out>=<in1_prio>;<in2_prio>;...;<inn_prio>}
Change the Audio Input Priorities
ȩ {PRIO_A<out>=<in1_prio>;<in2_prio>;...;<inn_prio>}
Network Configuration
Query the Current IP Status
ȩ {IP_STAT=?}
Set the IP Address
ȩ {IP_ADDRESS=<type>;<ip_address>}
Set the Subnet Mask
ȩ {IP_NETMASK=<subnet_mask>}
Set the Gateway Address
ȩ {IP_GATEWAY=<gateway_addr>}
Apply Network Settings
ȩ {ip_apply}
Enable/disable the Ethernet Port
ȩ {ETH_ENABLE=<switch>}
96