Lightware UMX-TPS-TX120 User Manual page 181


  
11. Appendix
▪ In case of sending 1920x1200 no sync screen, the device did not notice the connection state changes
on the inputs. Fixed.
▪ If the output was set to HDCP Always mode, the signal was sent out unencrypted, if the input port was
disconnected and connected again. This issue only happened, if the input signal was also unencrypted.
▪ Poe enable wasn't saved.
▪ Cable diagnostics properties are moved to SYS/MB/TPS/REMOTE node.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual 181