Factory Default Settings - Lightware UMX-TPS-TX120 User Manual


  
11. Appendix
11.2. Factory Default Settings
Parameter
Video
Audio
HDCP
Autoselect
Emulated EDID on analog video inputs
Emulated EDID on digital video inputs
Test pattern mode
Test pattern resolution
Test pattern color (RGB code)
Test pattern resolution on Testpattern input (I6)
Test pattern color (RGB code) on Testpattern input
(I6)
Output signal type
Output HDCP mode
Power 5V mode
Color space
TPS mode
Analog audio port settings (I1 and I5)
Volume
Balance
IP address
Subnet mask
Static gateway
DHCP
LW2 port number
LW3 port number
HTTP port number
Control protocol
Baud rate
Setting/Value
Crosspoint settings
I1 (VGA in)
I1 (Analog audio in 1)
Video port settings
Enabled
Disabled
Factory #89: Universal Analog EDID
Dynamic #1: Copy EDID from connected sink device.
Auto
640x480p
#7F7F7F (grey)
640x480p
#108020 (green)
Auto
Auto
Always on
Auto
Auto
0.00 dB (100%)
50 (center)
Network settings
192.168.0.100
255.255.255.0
192.168.0.1
Disabled
10001
6107
80
RS-232 settings
LW2
57600
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
Parameter
Databits
Parity
Stopbits
Operation mode
Command injection port nr. - Local
Command injection port nr. - TPS
Command injection status
Comm. inj. input port nr. - Local
Comm. inj. output port nr. - Local
Comm. inj. input port nr. - TPS
Comm. inj. output port nr. - TPS
Output level
Direction
Setting/Value
8
None
1
Pass-through
8001
8002
IR port settings
Enabled
9001
9002
9003
9004
GPIO port settings
High
Input
169