Connecting Steps; Powering Options - Lightware HDMI-TPS-TX210 User Manual


  
2. Installation
2.2. Connecting Steps
HDMI laptop PC
HDMI DVI
HDMI-TPS-TX200 series
transmitter
VIDEO AUDIO VIDEO AUDIO
HDCP
Autoselect
DP IN HDMI IN
Power GPIO
Power adaptor Relay box
Touch panel
CATx Connect the the transmitter and a compatible receiver or the matrix input board by a CATx cable via
the TPS connectors.
DVI Connect the transmitter and the sources using the inputs and DVI-I / HDMI / DisplayPort cables.
HDMI
DP
Audio Optionally connect an asymmetric audio device with unbalanced audio signal (e.g. a MP3 player)
to the 2.5" TRS (Jack) audio input port.
IR Optionally for Infrared control:
- Connect the IR emitter to the IR OUT port of the device.
- Connect the IR detector to the IR IN port of the device.
LAN
Optionally connect the transmitter to a LAN network in order to control the device.
RS-232 Optionally for RS-232 control: connect a controller/controlled device (e.g. touch panel) to the
RS-232 port.
GPIO Optionally connect a controller/controlled device (e.g. relay box) to the GPIO port.
Power
See powering options in the next section.
MacBook MP3 player
DP Audio
CATx
VIDEO AUDIO VIDEO AUDIO
RESET
AUDIO
VIDEO AUDIO SHOW
HDMI IN DVI-D IN 5 AUDIO IN SELECT SELECT ME
RS-232 LAN IR
Ethernet Infrared
HDMI-TPS-TX200 series – User's Manual
2.3. Powering Options
Power

Powering options

VIDEO AUDIO VIDEO
HDCP
Autoselect
DP IN HDMI IN
Compatible
receiver or
input board
A Using local PSU: connect the power adaptor to the DC input on the transmitter first, then to the AC
power socket.
Using PoE with connecting a transmitter: connect the TPS OUT (PoE) port of the transmitter to the
B
TPS+PoE port of the TPS-PI-1P1 power injector by a CATx cable, and connect the TPS input port of
the compatible receiver to the TPS port of the TPS-PI-1P1 by a CATx cable.
C Using PoE with connecting a matrix or an input board: connect the TPS OUT (PoE) port of the
transmitter to the PoE-compatible TPS input port of the matrix or input board by a CATx cable.
ATTENTION! In case of connecting the transmitter to an input board of the matrix always connect an
external PSU to the board. For the detailed information please read the user's manual of the matrix.
ATTENTION! The Ethernet port does not support PoE. Only the TPS port support PoE function.
INFO: If both remote and local power sources are connected, the remote power will be used.
A
TPS-PI-1P1
B
power injector
CATx cable
AUDIO VIDEO AUDIO VIDEO AUDIO
RESET REQUIRED POWER OVER 20W
12V DC OUT ACTIVE
REMOTE POWER OUT ACTIVE
AUDIO 48V DC IN PRESENT
VIDEO AUDIO SHOW
HDMI IN DVI-D IN 5 AUDIO IN SELECT SELECT ME
Transmitter
C
CATx cable
11
Power
Adaptor
CATx cable
Compatible
Power
receiver
Adaptor
Compatible matrix
or input board