Port Diagrams; Standalone Extenders; Wall Plate / Floor Plate Extenders - Lightware UMX-TPS-TX120 User Manual


  
4. Device Concept
4.3. Port Diagrams
4.3.1. Standalone Extenders
The following figure describes the port diagram of the UMX-TPS-TX140 transmitter. The principle of the
operation is the same for the following models.
▪ UMX-TPS-TX120, -TX130, -TX140
▪ UMX-TPS-TX140-Plus
UMX-TPS-TX140K
▪
Port diagram of the UMX-TPS-TX140 transmitter
The device has four video input ports to receive analog video (VGA, DVI-A) and digital video (HDMI, DP,
DVI-D) signals. The analog signals are converted to digital. A 5:1 digital audio/video switch decides which
signal is routed toward the TPS output port. The device also has two analog audio input ports (3.5mm Jack,
5-pole Phoenix). The analog signals are converted to digital ones. The user can choose which audio signal
is transmitted on the TPS output port: one from the analog audio sources or the original embedded audio
from the HDMI / DP / DVI-D ports.

INFO: The DVI-D input accepts HDMI signal with embedded audio as well.
Besides, the device has four different interfaces to control the unit itself or third-party devices: infrared (input
and output), RS-232, Ethernet, and GPIO.
Applied firmware packages: (UMX-TPS): v1.5.0b4 | (WP-UMX-TPS): v1.4.0b8 | (FP-UMX-TPS): v1.4.0b8 | LDC software: v2.5.6b2
UMX-TPS-TX100 series – User's Manual
4.3.2. Wall Plate / Floor Plate Extenders
The following figure describes the port diagram of the WP-UMX-TPS-TX130-US transmitter. The principle of
the operation is the same for the following models.
WP-UMX-TPS-TX120-US series
▪
▪ WP-UMX-TPS-TX130-US series
▪ WP-UMX-TPS-TX130-Plus-US series
FP-UMX-TPS-TX120
▪
▪ FP-UMX-TPS-TX130
Port diagram of the WP-UMX-TPS-TX130-US transmitter
The device has three video input ports to receive analog video (VGA) and digital video (HDMI, DP) signals.
The analog signal is converted to digital. A 3:1 digital audio/video switch decides which signal is routed
toward the TPS output port. The device also has an analog audio input port (3.5mm Jack). The analog
signals are converted to digital ones. The user can choose which audio signal is transmitted on the TPS
output port: the analog audio source or the original embedded audio from the HDMI / DP ports.
Besides, the device has four different interfaces to control the unit itself or third-party devices: infrared
(input), RS-232, and Ethernet.
40